I2C communication with DWM1001-DEV


I’m customizing my own firmware on DWM1001-DEV. I’m trying to have the dev board send data to some external device (e.g. Raspberry pi) using I2C but not sure what are the pins I’m able to use.

Currently I’m thinking about configuring two pins on J7 for I2C, but then realized there are two pins in J7 (marked “I2C” in DW1001 schematic) connected to the accelerator, and there are another two pins connected to DW1000.

If I wish to configure two pins from the GPIOs on J7 for I2C, should I avoid the above 4 pins?

Thank you,