DW1000 in an unknown state

We have developed a custom Tag with decawave DW1000.

Sometimes Tag don’t send, others don’t receive, others both.

I think that problem is what I read in datasheet of DW1000:

“Reapplying power while VDDAON is between 100 mV and 2.3 V can lead to the DW1000 powering up in an unknown state which can only be recovered by fully powering down the device until the voltage on VDDAON falls below 100 mV”

My question is, How can I detect by firmware that DW1000 is in this state in order to apply a full powering down and reset, by disable and enable power supply??